Debug PX4 Replay with Eclipse

-

 Just screenshot how to do setup





Comments

Post a Comment

Popular posts from this blog

QUAD SPI Logic Analyzer Saleae Plugin

-
Image
If you are looking for Plugin to read your QSPI data for Logic. Here it is! You can compile it and use it: https://github.com/Igor-Misic/saleae_qspi It will look like this: If you don't have time to compile it, you can buy a 64bit Linux library. You will just need to place it in the "Analyzers" folder of the Logic program and restart Logic. The price is 4.99 USD. If you will have any problems with purchasing contact me over this blog.
Read more

Winbond NAND flash W25N01GV - problem while flashing one page multiple times

-
Image
 I run into a problem while using W25N01GV. Since I couldn't find an answer on the internet I contacted Winbond support. Here is my conversation so maybe it will help you as well.  Question 1  : Hi, I am using W25N01GV on different projects and recently I found a problem while writing multiple data on the same page. With command Load Program Data (02h) I am loading data to Data Buffer and then I store it to flash with Program Execute (10h). Each time I am writing to a different column address on the same page. After around 200 writes on the same page some old data seems to change, even I didn't write anything at their location. Any chances there is a limit to how much time could be one page used before erasing the whole block? or this could be a faulty sample of flash? Best regards, Igor Misic (2020-11-29 19:06:17) Answer 1  : Hi Igor: Thank you for contacting Winbond. About the SPI NAND flash, there are two limitation for page program operation. 1. There are 4 ...
Read more

AUTOSAR and CRC calculation

-
Image
If you find yourself reading AUTOSAR document Specification of CRC Routines you are probably looking for a solution on how to implement it in your code. This is short instruction without explaining how CRC works. It includes working CRC code with examples from the mentioned documentation. Explanation of CRC8 CRC 8 it means, the polynomial of CRC is 8 bit long.  Explaining chapter 7.2.1: CRC result width - it is the return value, it says it is 8 bits long Polynomial - this value is used to calculate CRC. In this case, it is 0x1D Initial value - CRC calculation start with this value. It is usually all F's or zeros.  Input data reflection - it says if the data which you want to do CRC need to be reflected or not. Example of data reflection: hex: 0x73 or binary: 1110011, reflected value is: 1100111 or hex 0x67 Result data reflected - same as input data, but the only result is reflected XOR value - result value need to be XOR-ed with this value before...
Read more